『Butter flowmeter』Related information(clamp on meter|electromagnetic meter|venturi meterrotameter|orifice meter|ultrasonic flow meter|mass flow meter|coriolis mass flow meter|coriolis flow meter|magnetic flow meter|magmeter flow meter|magflow flow meter|mag meter flow meter|electromagnetic flow meter|vortex flow meter|turbine flow meter|thermal mass flow meter|thermal flow meter|rotameter flow meter)
How is an electromagnetic flowmeter maintained on a regular basis? Waiting for an answer:
The function of the electrode of an electromagnetic flowmeter is to generate an induced potential signal proportional to the measured value. If there is a problem with the electrode, the electromagnetic silver positive flowmeter will not be able to function normally. Therefore, electrode maintenance is very important. Regarding the electrode maintenance of an electromagnetic flowmeter, it is recommended to refer to the following:
1. Before using an electromagnetic flowmeter, it is necessary to calibrate it with a standard pH solution.
. After calibration, before operation, everyone must pay attention to cleaning the electrodes of the electromagnetic flowmeter with distilled water first, and then cleaning the electrodes again with measuring solution.2. If you do not use an electromagnetic flowmeter, when removing the electrode of the electromagnetic flowmeter, be careful not to let the tactile sensor of the electrode collide with a hard object, otherwise any damage will affect the use of the electrode.
.3. After using the electromagnetic flowmeter, everyone should put the electrode of the electromagnetic flowmeter on top and put less saturated solution inside. Just make sure that the electrode bubbles are moist, but remember not to soak them in distilled water.
.4. It is important to keep the electrodes clean and tidy, and avoid short circuits on both sides of the output, as this may result in inaccurate measurements and affect the use of the electromagnetic flowmeter.
. Everyone should pay more attention during use and not let their own small negligence cause the electromagnetic f
2. What are the precautions for an automatic butter pump?
Precautions for automatic butter pump:
1. When connecting the power, check the integrity of the equipment first.
. Preheat the equipment;2、 Before the whole machine starts working, check whether the motor rotation is correct (facing the triangular pulley, it should rotate clockwise);
3、 Push the copper cap on one side of the counter on the flowmeter inward, (referring to the 1st stage) 2nd stage flowmeter. After each indication is complete, rotate the handwheel counterclockwise and set the size pointer back to zero. The pointer of the counting disk will automatically return to zero. If continuous counting is required, the copper cap will no longer be pressed;
4、 Controlling the tightness of the gripper plate of the oil gun can roughly adjust the oil output;
5、 Ordinary cables shall not be used to replace the dedicated rubber sheathed cables of this machine, nor shall they be disassembled or connected arbitrarily;
6、 The inlet and outlet pipes, oil guns, and cables should be wound around the designated positions when not in use, and should not be dragged anywhere. Before inserting the pipes into the oil tank (or oil drum), they should be cleaned and tidy;
7、 After using the finished product, it is necessary to clean the inlet and outlet pipes as well as the oil outlet hose.
3. What oil can replace lubricating oil in natural gas flow meters?
Add instrument oil or sewing machine oil to natural gas turbine flow meters, as well as machine oil and butter.
.
Hot Blog
Related AD
